FXR DIVISION Streetwitch Handle Bars for Street Glide Models

eZy Watermark_09-03-2019_11-15-43AM.jpg
IMG_2509.JPG
eZy Watermark_09-03-2019_11-11-07AM.jpg
IMG_2508.JPG
eZy Watermark_09-03-2019_11-12-35AM.jpg
eZy Watermark_09-03-2019_11-16-57AM.jpg
eZy Watermark_09-03-2019_11-15-43AM.jpg
IMG_2509.JPG
eZy Watermark_09-03-2019_11-11-07AM.jpg
IMG_2508.JPG
eZy Watermark_09-03-2019_11-12-35AM.jpg
eZy Watermark_09-03-2019_11-16-57AM.jpg

FXR DIVISION Streetwitch Handle Bars for Street Glide Models

from 424.99

FINALLY… A Comfortable, Narrow, Performance Handle Bar for HD Street Glide Models !!!

At FXR Division, we Blended the T Bar Feel and Wrist Angle of our FXR Division Motorwitch Bars and made these for ALL Street Glide Models (2008 and Earlier would require Upgrading to the 2009 and Newer Brembo Style Master Cylinder)…

The MOST NARROW Street Glide Specific Handlebars in the Industry… And made to the same HIGH STANDARDS with BEST Materials available !!! These bars allow FULL Use of your Factory Gauges and Navigation/Media Center WITHOUT ANY MODIFICATIONS!!!

The FXR Division Streetwitch Bars for Street Glides measure and Impressively Narrow 33” from end to end… You won’t look or feel like a kite flying down the road and your hands will not be protruding WAY outside your fairing !!!

The only way to have a more narrow bar on your Street Glide is to go with an Offset Plate and a set of our FXR Division Split Angle or FXR Division Split MX Bars.

Like our Split MX, Split Angle, and G Series Bars… we manufacture these IN HOUSE out of 1.250 X .125 steel tubing, we make sure to debur ALL material inside and out prior to welding for the smoothest wire pulls, and like ALL of our FXR Division Bars, are Throttle By Wire READY!

Comes in Gloss Black Powder Coat.

** If your OEM Perch Clamp has a locating pin… it will be necessary to remove it before installation**

*** Don't forget to get a set of NEW Gooden-Tite FLT Handlebar Bushings to go with your bars!***

****We normally DO NOT stock bars over 16”… they are Made To Order and may take a little bit longer to manufacture and ship… Orders for Bars over 16” WILL BE subject to a 20% Cancellation Fee if order is cancelled after 7 Days from the Date the Order was placed***

ALL FXR DIVISION PARTS ARE PROUDLY MADE AND MANUFACTURED IN THE USA.

Height:
Quantity:
Add To Cart