MotoGadget M.Unit- Basic
MotoGadget M.Unit- Basic
TRASH that OLD OEM Wiring Harness and Get the MotoGadget M.Unit- Basic!!!
By Far the CLEANEST way to re-wire your FXR!!! Gets Rid of that Rats Nest of Relays, Jumpers, and Wires!!! Click Here——> circuit diagram with use of m.button …
The new m.unit basic without Bluetooth® LE has moved on from the established m.unit v.2 by undergoing significant development and improvements. It is now equipped with 12 inputs, 10 outputs and replaceable high-quality cable clamps. It offers the same features like the m.unit blue but without Bluetooth® LE und connectivity to the m.ride app.
The m.unit basic is the digital control unit for your motorbike – the heart of the entire on-board electrical system. It can be operated using buttons or using conventional handlebar switches. It controls all necessary components on the vehicle while also performing fuse functions.
There are considerably fewer relays and individual components in the wiring harness and the vehicle can be rewired with less effort in a very short amount of time.
Complete digital control using buttons possible with 4 or 5-button operation. Also latching switches possible
Complete replacement for the fuse box. 10 independent circuits are digitally monitored and switched off if there are faults. After the fault is rectified, the safety function is automatically reset.
Integrated alarm system that can be installed in any position.
Integrated, digital flasher relay that is load-independent; automatic switch-off optional and can be set; m.wave mode can be selected.
Integrated hazard warning light.
Turn signal can optionally be set as a positioning light.
Integrated parking light and headlight flashing.
Lo-beam and Hi-beam (up to 200 W switched capacity) can be controlled using only one button.
Integrated, digital brake light modulator; flashing mode can be programmed.
Acceleration-controlled emergency brake light (automatic warning signal).
Integrated starter relay for the starter system with solenoid (up to 30 A switched capacity).
Intelligent and configurable management/switch-off of power consuming devices so that the maximum starting energy from the battery can be used when starting the motorbike.
Integrated, digital horn relay.
Two configurable additional outputs AUX1 and AUX2.
Diagnostics function for assigning inputs, outputs, the circuit switching status, short circuit diagnostics etc.
Calibration and current measurement enables faults to be detected on all lamps.
COMPLETE WIRING DIAGRAM PICTURED USING THE M UNIT CABLE KIT AND OEM COLOR CODED 96’ AND UP SWITCH CONTROLS…. HUGE THANK YOU TO MICHAEL HUTCHINGS (@hutchings08) FOR TAKING THE TIME AND PUTTING THIS TO OUT THERE !!!
***We do our Best to keep these In Stock and Available. However, they are an import part which may cause a delay in shipping. If that occurs, you will be notified via email***